Symmetry and subdivision
On this page
Symmetry keeps both halves of a model consistent while you build, and subdivision preview shows how the low-poly cage will smooth. Both workflows are available from the SYMMETRY control in the mode bar and the SUBDIVISION inspector section.
Symmetry planes#
Choose a plane in RETOPOLOGY → Plane:
| Plane | Use |
|---|---|
| X | Mirrors the X coordinate across the YZ plane. |
| Y | Mirrors the Y coordinate across the XZ plane. |
| Z | Mirrors the Z coordinate across the XY plane. |
| Custom | Uses an oriented plane with Yaw and Pitch controls. |
Plane offset moves the active plane along its normal from −50% to 50% of scene size. The offset applies to the built-in and custom planes.
To reuse a plane, type a name in Plane name and click Save. Saved planes appear under SAVED PLANES; click a name to use it, or click its x button to delete it. The active plane is used by Live symmetry, Mirror plane, Flip mesh, Zero snap, and Split at symmetry plane.
Live symmetry#
Click SYMMETRY in the mode bar to turn Live symmetry on or off (or use the Topology menu). The arrow joined to the button opens the settings: plane, offset, saved planes, and Mirror / Flip / Zero Snap / Split. While it is on:
New faces created by the drawing and creation tools are mirrored across the active plane.
Moves, rotations, and scales affect the mirrored vertices as well.
Deleting components removes the matching components on the other side.
Insert loop, Connect, Delete edges, Bridge, and Subdivide selected islands are symmetry-aware.
Vertices created near the plane snap onto it, which avoids a seam between halves.
A strip, a patch or a circle drawn across the plane ends on the plane: one half is built and mirrored, and the two halves share the vertices on the plane.
Turn Live symmetry on before building the second half. If you already built one half, use Mirror plane to copy it and enable symmetry at the same time.
Mirror, flip, zero snap, and split#
| Command | Result |
|---|---|
| Mirror plane | Copies the existing retopology across the active plane and turns Live symmetry on. If the mesh is already symmetric, nothing is added. |
| Flip mesh | Moves the entire retopology to the other side of the active plane and reverses the face winding. |
| Zero snap | Snaps vertices that are already close to the active plane onto it. |
| Split at symmetry plane | Cuts the retopology along the active plane, including faces and wire edges. It does not delete either side. |
These commands use the current plane and offset, so check the Plane and Plane offset controls before running them.
Subdivision preview#
Turn on View → Subdivision preview or enable Preview in the SUBDIVISION section. QuadPen uses Catmull-Clark subdivision at levels 1 through 5.
The reference is hidden while the preview is active, and the smoothed surface is drawn in amber.
Project to reference shrink-wraps the preview onto the high-poly surface. Turn it off to see the plain subdivided cage.
Update rebuilds the preview after changing the level or toggling projection.
Toggle turns the preview off and on.
The level slider changes the preview immediately.
The preview is a display of the current retopology; it does not replace the editable cage. Use Export… (in Subdivision) in the same section to write the mesh at the current level; the system's file window asks where.
Local subdivision#
Use Modify → Subdivide selected islands or Subdivide islands in the inspector to subdivide selected regions without splitting the whole mesh. Every face in a connected island must be selected; partially selected islands are left untouched and the status bar reports how many faces were skipped. This avoids T-junctions and keeps the result watertight.
Use Subdivide in the inspector to split every face in the retopology. The command is available for quads and triangles.